Yes, you can mount a transducer inside your kayak. The recommended method is to use waterproof silicone to adhere the transducer to the hull, making sure to clean the area thoroughly with alcohol first. Alternatively, you can use epoxy or Goop, just making sure there are no bubbles in the adhesive. Additionally, you can use the putty method to “shoot through the hull”. This method involves using putty to adhere the transducer to the inside of the kayak, allowing the signal to pass through the hull to the water.
Where should a kayak transducer be placed?
A kayak transducer can be mounted in several places, depending on the type of transducer and the kayak model. The most popular places to mount a transducer are through the hull, through the scupper holes, with an attached side-arm mount, in a built-in transducer location, and on the top of the kayak. Additionally, some kayaks are designed with built-in transducer pockets, which allow you to place the transducer inside the kayak. To ensure the best performance, it is important to place the transducer in an area that is free of any potential obstructions, such as the hull, scupper holes, and other objects. Additionally, it is important to make sure the transducer is positioned properly in order to maximize its performance.
Can I install transducer inside the boat?
Yes, you can install a transducer inside a boat, either on the transom or bonded to the hull’s interior. However, it is important to keep in mind that you may lose some sonar performance when shooting through fiberglass, so it is best to consult with a professional if you are unsure of the best way to install the transducer. Additionally, if installing on the interior of the hull, make sure to use a two-part slow curing adhesive for the best bond.
How do you attach a transducer to a kayak?
Attaching a transducer to a kayak can be done in several ways. You can mount the transducer inside the hull of the kayak using duct sealant and waterproof silicone, or you can use a specialized mounting arm or bracket to attach the transducer to the side of the kayak. If you choose to mount the transducer inside the kayak, make sure to clean the area thoroughly and apply the sealant and silicone carefully. If you opt to use a mounting arm or bracket, make sure to follow the manufacturer’s instructions and use the appropriate mounting hardware.
Where is the best place to mount a transducer on a boat?
The best place to mount a transducer on a boat is close to the keel (centerline of the boat), as close to the center of the boat as possible, but on the side of the downward swing the propeller. It should be mounted to the starboard side, which is the down stroke of most single outboard boat propellers, and should be as close to the centerline as possible but at least 3 inches outside the swing radius of the prop blades. For twin drives, mount one transducer on each side. If you plan to trailer your boat, do not mount the transducer too close to the transom, as this can cause turbulence and affect its performance. On fiberglass bass and walleye boats, high speed readings can be obtained by placing the transducer on the bottom step, down where the livewell pickup and pump are typically located.