Yes, ClearVu transducers can be used with a thru-hull installation. However, the performance of the transducer may be reduced due to the additional thickness of the hull. There are also special transducers that are designed to be used with a thru-hull installation, such as the Garmin GT34UHD-TH Thru-Hull transducer.
Does Down imaging work through hull?
Down Imaging transducers are designed to be mounted on the outside of the hull, and will not work when mounted on the inside of the hull. This is because the imaging technology requires a clear line of sight in order to accurately image the bottom of the lake or ocean. If the transducer is mounted inside the hull, it will not be able to scan the bottom of the lake or ocean. Additionally, the transducer must be mounted in an area where the hull is relatively thin, such as the transom, in order to ensure that the imaging signals can pass through the hull.
Will a transducer work through hull?
Yes, a transducer will work through a hull. Through-hull transducers are designed to be mounted on the outside of the hull and penetrate the hull material, allowing the ultrasonic pulse waves to pass through the interior of the hull. This is the most common type of transducer installation and is usually the most reliable. However, it is important to make sure that the material of the hull is suitable for a through-hull installation, as some materials may not be suitable for this type of installation.
Will a transducer work through an aluminum hull?
Yes, a transducer can work through an aluminum hull. However, the thickness of the aluminum hull will determine how effective the transducer will be. For example, a standard transducer may not be able to transmit through an aluminum hull thicker than 0.150 inches. In this case, you may need to use a transducer specifically designed for aluminum hulls, such as the Vexilar AlumaDucer. Additionally, you may need to use an epoxy to mount the transducer to the hull, as this will increase its strength and ensure that it is securely mounted.
Can you mount a transducer in the hull of a kayak?
Yes, you can mount a transducer directly in the hull of a kayak. This is usually done via duct seal or plumber’s putty. This is a good option for 2D sonar, as it allows the transducer to be placed closer to the bottom of the kayak, resulting in better sonar performance. However, be sure to properly seal the transducer to prevent water from getting inside the kayak. Additionally, you may need to use a junction box to route the wiring through the hull.